Author Topic: BIAB batch sparge grain absorption  (Read 374 times)

Offline Javaslinger

  • BeerSmith Brewer
  • ***
  • Posts: 28
  • Karma: 0
  • BeerSmith 2 Rocks!
BIAB batch sparge grain absorption
« on: October 10, 2017, 09:30:48 AM »
Curious what people set their grain absorption to when doing BIAB with a batch sparge?

BIAB Default 0.586 fl oz/oz
Mash Tun Default 0.960 fl oz/oz

So if using a mash profile such as Single Infusion, Batch Sparge while doing BIAB, should I set it to 0.586 or somewhere in the middle.  I know I can back calculate from a brew day, but I'm trying to get a ball park to begin with from everyone else.

Thanks!

Offline Oginme

  • BeerSmith Grandmaster Brewer
  • *****
  • Posts: 1322
  • Karma: 64
  • Goats, guitars, and a home brew; Life is good!
    • Longvu LaManchas
Re: BIAB batch sparge grain absorption
« Reply #1 on: October 10, 2017, 10:12:18 AM »
I measure my grain absorption for every batch (along with boil off rate) and track it.  I've set my grain absorption to my BIAB value in the standard options, since I do mostly BIAB brewing. 
Recycle your grains, feed them to a goat!

Offline tdev

  • BeerSmith Apprentice Brewer
  • **
  • Posts: 5
  • Karma: 0
Re: BIAB batch sparge grain absorption
« Reply #2 on: December 07, 2017, 04:54:19 PM »
I see the default is .586 Oz/oz but when i measure mine it is around .27-.33 - this is far from the .586 - what are other people seeing?  Thanks

Offline GigaFemto

  • BeerSmith Master Brewer
  • ****
  • Posts: 98
  • Karma: 2
  • Muonic Matter Rocks!
Re: BIAB batch sparge grain absorption
« Reply #3 on: December 07, 2017, 06:03:25 PM »
I do 5 gallon BIAB batches with grain weights of 11-13 lbs and I get very close to the default of 0.586. My volumes are so close I have seen no reason to change from the default. I do squeeze the heck out of my bag to get all the goodness out. If you don't squeeze I can see you getting higher absorption, but it is hard for me to see someone getting half.

I suddenly had a thought that the grain absorption may be affected by the grain crush. I have a mill gap of 0.025", and I double crush. It might be that a coarser grain crush would result in lower water absorption if the water doesn't penetrate all the way through the larger pieces in the same proportion as smaller pieces.

--GF