Author Topic: Intermittent Pilot Spark Ignition Banjo Burner/s  (Read 396 times)

Offline BeerBrewinWizard

  • BeerSmith New Brewer
  • *
  • Posts: 1
  • BeerSmith 2 Rocks!
Intermittent Pilot Spark Ignition Banjo Burner/s
« on: January 13, 2019, 06:56:37 AM »
I have been using a Standing Pilot on each of my three BG14 Burners (25 Gallon Pilot Brew Rig) but wanted to step it up a notch. I have been testing a Honeywell intermittent pilot spark ignition system on one burner. Since I wanted to try to use my existing MyPin TA4 PID Controls I found a few hurdles. Everything works well until the liquid temp gets close to the SV but then would start quick cycling. While this is not much of a problem with electric heat except for wearing out of contacts) it is obviously an issue when gas. So, I turned the P to off and set the hysteresis to -2 & +1. So far so good. I am assembling the new wiring in my controls now. Attached is a picture of my mobile pilot brew rig.

Offline brewfun

  • BeerSmith Grandmaster Brewer
  • *****
  • Posts: 2175
  • STAND BACK! I'm going to try Science!
Re: Intermittent Pilot Spark Ignition Banjo Burner/s
« Reply #1 on: January 13, 2019, 09:17:12 PM »
Nice rig!

Yup, giving yourself a little more headroom in hysteresis should stop the rapid cycle chattering.

I see you're also using the CAM connectors. I've got those on a pilot rig I'm assembling, too.
Beer Appreciation is the space between pints.

 

modification